Final grinding would have to wait for a day to allow slow cooling. Doing the whole face might take all day, even for a skilled weldor. What other options might I have? The good news is that this is otherwise a fantastic anvil, and if I must I also have a decent sized Vulcan that is in good shape and can cover my hardie tool needs.Įven with cleaning, preheating, welding, chipping and wire brushing, a section that small should be finished before lunch. This is the article I have been basing my strategy on Īll work done at a reasonable local heat of something like 300 degrees F. Then take welding rods of certain types and building up as needed. ![]() What I was told by the gentleman I bought this from is to get a piece of "tool steel" (which is very vague as there are many types), add lead to the area and set the new piece into place. Can the hardie hole be made usable again (assuming I make a removable seat to relieve any stress from working with hardie tools)? What type of tool steel would be a good filler plate? What method would you use to repair this? I understand that even a good repair will not make them as good as new but I need something to work with. Here is the damage, my issue is that it doesn't allow me to use the pritchel and hardie holes. I've just purchased a 196lb peterwright anvil, and it is missing a large section of the steel face at the heel.Ĭlose up of the markings for your viewing pleasure ![]() Hello! I've got a tough one for you folks.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |